InventorCAM iMachining – Exer #5: Helical Entry, Pre-Drilling and small tools

By ResearcherStore Categories: A-Technology
Wishlist Share
Share Course
Page Link
Share On Social Media

About Course

InventorCAM iMachining – Exer #5: Helical Entry, Pre-Drilling, and small tools

This course is Exercise #5 of the Interactive Training Course for iMachining. In this course, you will become more familiar with Helical Entry, the use of Pre-Drilling techniques as well as the performance of small tools in iMachining 2D. Load the Inventor CAM part used in this exercise – EXERCISE_5.prz. The CAM-Part and iMachining Data are defined. Four tools are also defined – two milling tools and two drilling tools. And much more.
Show More

Course Content

InventorCAM iMachining Training Course

  • InventorCAM iMachining Training Course – Exer #5: Load the CAM-Part
    00:00
  • InventorCAM iMachining Training Course – Exer #5: Machine the main pocket…
    00:00
  • InventorCAM iMachining Training Course – Exer #5: Helical Entry
    00:00
  • InventorCAM iMachining Training Course – Exer #5: iRest and iFinish the main pocket
    00:00
  • InventorCAM iMachining Training Course – Exer #5: Pre-Drilling a small hole prior to roughing
    00:00
  • InventorCAM iMachining Training Course – Exer #5: Pre-Drilling a large entry hole
    00:00
  • InventorCAM iMachining Training Course – Exer #5: Machine the top of the island
    00:00
  • InventorCAM iMachining Training Course – Exer #5: Machine the holes
    00:00
  • InventorCAM iMachining Training Course – Exer #5: iMachining with small tools
    00:00
  • InventorCAM iMachining Training Course – Exer #5: Machine the counterboressson
    00:00
  • InventorCAM iMachining Training Course – Exer #5: Machine the vent slots
    00:00

Student Ratings & Reviews

No Review Yet
No Review Yet